calibration models in WCS

Unanswered Question
Nov 7th, 2007

i would like to calibrate an outdoor area in cisco's WCS, using RF calibration models.however, when i try to do this i don't get the option of choosing my "outdoor area", i have to choose a "floor".. how do i get to calibrate my outdoor area?

anyone have experience with the pre-programmed model "outdoor open space", and how the performance is?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
dennischolmes Thu, 11/08/2007 - 08:09

Location services are not officially supported as of yet by Cisco. The reason for this is that Cisco used RF Fingerprinting for location services and the density of APs required as well as antenna diversity was not incorporated into the 1510 series APs. As Cisco moves slowly towards TDOA I suspect you will see more and more support for outdoor location services.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode