Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
261
Views
5
Helpful
1
Replies

Using Embedded Event Manager

jthomson
Level 1
Level 1

‎11-07-2007 03:02 PM - edited ‎03-03-2019 07:26 PM

I would like to find out if you can use the extended ping cli command within EEM. If not is there some way I can specify the source address for a ping within EEM?

Labels:
0 Helpful
1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

‎11-09-2007 08:54 AM

You can certainly use an extended ping with EEM. You don't even have to have it interactive. For example:

ping ip 10.1.1.1 source 11.1.1.1 ...

You would then process the output of this command as you would any other in EEM. I have a library that helps interact with the CLI within an EEM TCL policy at http://www.cisco.com/go/ciscobeyond/ . You may find that helpful.

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card