time display on 7941 & 7961

Unanswered Question
Nov 8th, 2007
User Badges:

I set the system clock to the correct time but the phones are showing 5 hours earlier. The display was right about a week ago then the vendor changed something and now I can't get the phones to read the right time. No matter what I set the system time to the phones never change. Is there a command to tell the phones what time to display and how do you set it?


thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
joergwesely Fri, 11/09/2007 - 03:09
User Badges:

Seems like the timezone is not set correctly


Have you checked the Date/Time-group in the callmanager?

allan.thomas Sat, 11/10/2007 - 08:48
User Badges:
  • Blue, 1500 points or more

Reset the IP Phone's respective Device-Pool, however be cautious when doing this depending on how many devices are registered at time.


If your large numbers of phones I would recommend this course of action is carried out of hours.


When the phone registers to CCM is should pickup the correct time. As a test you could perhaps reset one IP Phone, and when you are assured this works proceed to restart the others.


Regards

Allan.


Pls rate this post if you find it helpful

Actions

This Discussion