Rate Lmitnig a VLAN interface

Unanswered Question
Nov 9th, 2007
User Badges:

I have just installed a L2 MPLS network using 7604 routers at the hub sites and 3845 routers at my edge. I would like to configure rate limiting on my devices.


On the 3845 I have implimented a Service-Policy on on my Ethernet Sub interface and this is owrking perfectly.


On the 7604 I use VLAN interfaces and the interface does not support shaping in the same manner.


Here is the config on my 3845


policy-map Max-Bandwidth

description Rate Limit for WAN Link

class class-default

shape average 24000000


bandwidth 20480

encapsulation dot1Q 904

ip address 10.2.252.10 255.255.255.252

ip tcp adjust-mss 1300

ip ospf cost 400

crypto map ToDC1

service-policy output Max-Bandwidth



On my 7604 this is the message I get when I try to apply the service-policy output command:



agdc01rtr01(config-if)#service-policy output Max-Bandwidth

shape average command is not supported in output direction for this interface

Configuration failed on:

Vlan504


What alternate methods are available to perform this peak bandwidth limiting on a VLAN interface?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion