2821 T1 Config

Unanswered Question
Nov 9th, 2007
User Badges:

I have a 2821 with a VWIC2-MFT-T1 connected to a T1 slot on and IAD running Voice for VoIP system and the same card is carrying data through the T1. How can I setup ATM on the VWIC to match the ATM settings on the IAD?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
allan.thomas Fri, 11/09/2007 - 15:23
User Badges:
  • Blue, 1500 points or more

In order to setup or configure the VWIC, you will require an ATM-AIM module. Ensure that you have the appropriate AIM depending on your requirements. Refer to the following link for supported AIMs.


http://www.cisco.com/en/US/products/hw/modules/ps2641/products_data_sheet09186a0080088753.html


Under the appropriate controller you specifiy mode atm aim 0 as shown below.


controller T1 0/1/0

mode atm aim 0


This will then enable you to configure the appropriate ATM interface configuration as in the following example:-


interface ATM0/1/0

description ???????/

bandwidth 1500

no ip address

no ip redirects

no ip unreachables

no ip proxy-arp

scrambling-payload

no atm ilmi-keepalive

!

interface ATM0/1/0.1 point-to-point

ip unnumbered Loopback0

no ip redirects

no ip unreachables

no ip proxy-arp

pvc ?/??

vbr-nrt 1500 1500 1

oam-pvc manage

oam retry 5 5 10

encapsulation aal5snap

Regards

Allan.


HTH.


Pls rate this post if you find it helpful.

Actions

This Discussion