Setting up MeetMe Conference Line

jmcconne10 · ‎11-09-2007

I've setup a 3825 with c3825-spservicesk9-mz.124-11.XJ4.bin and CME 4.1. I'm trying to follow the directions from the "Cisco Unified Communication Manager Express System Administrator Guide.pdf"to setup a MeetMe conference line. I've attached the config and the results of "debug ephone detail".

When I hit MeetMe and then dial 1101 (our MeetMe line) I get an error that says "No Conference Bridge". Does anyone have any ideas? Thanks in advance.

Rob Huffman · ‎11-09-2007

Hi Joe,

Sounds like a DSP issue for sure. Have a look at this post that answers alot of CME/Meet-me questions.

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddd5186/12#selected_message

Hope this helps!

Rob

jmcconne10 · ‎11-14-2007

Ended up I needed another ephone-dn with the MeetMe phone number. Must've missed that in the directions.