11-09-2007 01:24 PM - edited 03-15-2019 07:09 AM
I've setup a 3825 with c3825-spservicesk9-mz.124-11.XJ4.bin and CME 4.1. I'm trying to follow the directions from the "Cisco Unified Communication Manager Express System Administrator Guide.pdf"to setup a MeetMe conference line. I've attached the config and the results of "debug ephone detail".
When I hit MeetMe and then dial 1101 (our MeetMe line) I get an error that says "No Conference Bridge". Does anyone have any ideas? Thanks in advance.
11-09-2007 01:40 PM
Hi Joe,
Sounds like a DSP issue for sure. Have a look at this post that answers alot of CME/Meet-me questions.
Hope this helps!
Rob
11-14-2007 08:58 AM
Ended up I needed another ephone-dn with the MeetMe phone number. Must've missed that in the directions.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: