11-10-2007 01:17 PM - edited 03-03-2019 07:29 PM
hi, i have configured the router to dial PPPoE connection and do natting & routing:
ip nat inside source route-map Connection_1 interface Dialer1 overload
ip route 0.0.0.0 0.0.0.0 Dialer1
route-map Connection_1 permit 10
match ip address 1
match interface Dialer1
anyway, everything works fine, except for few strange issues,
such as, when i tun P2P client, the speed become very slow behind the router, if i connect the P2P client directly to the internet, it's very fast.
id like to know why, what causes that natting is not functioning well when i use P2P, while almost all other applications run smoothly?
11-11-2007 05:52 AM
Well, what does your access-list 1 look like?
What router model are you using ?
How much load is there on the processor when using P2P? ("sh proc cpu his")
And do you have firewall features (CBAC/inspect) enable on the router?
11-11-2007 12:49 PM
hi, thanks for reply, here is the ansowers:
access-list 1 permit 192.168.1.0 0.0.0.255
dialer-list 1 protocol ip permit
Router Cisco 3845
the load is not that much, i am currently the only user using it for testing.
cpu < 1% utilization, and memory is almost free.
no firewalls enabled at all at the router..
11-12-2007 07:32 AM
Can you show the full configuration on your router?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: