cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
567
Views
0
Helpful
3
Replies

Natting Problems

xbaha54321
Level 1
Level 1

hi, i have configured the router to dial PPPoE connection and do natting & routing:

ip nat inside source route-map Connection_1 interface Dialer1 overload

ip route 0.0.0.0 0.0.0.0 Dialer1

route-map Connection_1 permit 10

match ip address 1

match interface Dialer1

anyway, everything works fine, except for few strange issues,

such as, when i tun P2P client, the speed become very slow behind the router, if i connect the P2P client directly to the internet, it's very fast.

id like to know why, what causes that natting is not functioning well when i use P2P, while almost all other applications run smoothly?

3 Replies 3

tekha
Level 3
Level 3

Well, what does your access-list 1 look like?

What router model are you using ?

How much load is there on the processor when using P2P? ("sh proc cpu his")

And do you have firewall features (CBAC/inspect) enable on the router?

hi, thanks for reply, here is the ansowers:

access-list 1 permit 192.168.1.0 0.0.0.255

dialer-list 1 protocol ip permit

Router Cisco 3845

the load is not that much, i am currently the only user using it for testing.

cpu < 1% utilization, and memory is almost free.

no firewalls enabled at all at the router..

Can you show the full configuration on your router?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco