cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
566
Views
0
Helpful
1
Replies

loopback test

vinodbharwani
Level 1
Level 1

Hi

I have 3600 router which is connected over E1 link to other router.

I want to give soft loop from router toward BERT meter, can it possible.

I hve done following things

config t> int Se0/1

then go to loopback command and execute , but BERT meter could not detect that loop , is there any other way to give loopback toward BERT side

-Vinod

1 Reply 1

royalblues
Level 10
Level 10

Try to give a hard plug loop towards the Bert meter by shorting pins 1-4 and 2-5

Then use the same connector on your module and see whether the controller detects the loop.

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a008010059a.shtml#topic1

HTH

Narayan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: