Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
699
Views
6
Helpful
4
Replies

RTP/RTCP stream load balancing with CSS

Branimir Turk
Level 1
Level 1

‎11-12-2007 11:36 AM

Hi,

Is there any way to load balance RTP/RTCP streams with css?

Labels:
0 Helpful
4 Replies 4

Diego Vargas
Cisco Employee
Cisco Employee

‎11-13-2007 07:27 AM

Hi,

The CSS is able to balance the traffic at layer 4 (just looking at the ports), so there should be no problem.

The trick is to give the correct TCP port numbers.

About RTP/RTCP, I am not familiar with the protocol, but if it works with TCP, then here again, the correct port numbers should work.

Hope it helps!!

Branimir Turk
Level 1
Level 1
In response to Diego Vargas

‎11-14-2007 10:25 AM

Hi,

I agree about TCP, but it seems that RTP is using dynamicly assigned ports.

0 Helpful

Diego Vargas
Cisco Employee
Cisco Employee
In response to Branimir Turk

‎11-14-2007 11:02 AM

If the ports are not always the same you can have the CSS configured with a layer 3 rule (listening for any TCP port).

Branimir Turk
Level 1
Level 1
In response to Diego Vargas

‎11-15-2007 11:50 PM

Tnx for the info.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents