Ok, A buddy of mine has 2 bonded T1s and I'm upgrading to 4. For some reason he bought the vwic-2mft-t1 and wants to do data only with it. When I go to do the channel group it drops my connection. I can only do it remotely. Any ideas?
controller T1 0/3/0
framing esf
linecode b8zs
!
controller T1 0/3/1
framing esf
linecode b8zs
!
!
interface MFR1
description EMBARQ Multilink Frame Relay
ip address 10.10.10.10 255.255.255.252
encapsulation frame-relay IETF
frame-relay multilink bid EMBARQ
frame-relay interface-dlci 57
frame-relay lmi-type ansi
!
interface FastEthernet0/0
no ip address
duplex full
speed 10
no mop enabled
!
interface FastEthernet0/0.99
description Connection to Wireless with VLAN 99 TAG
encapsulation dot1Q 99
ip address 141.141.141.141 255.255.255.248
no snmp trap link-status
!
interface Serial0/0/0
description Connection 1 to EMBARQ MFR
no ip address
encapsulation frame-relay MFR1
no ip route-cache
service-module t1 timeslots 1-24
no arp frame-relay
!
interface Serial0/1/0
description Connection 2 to EMBARQ MFR
no ip address
encapsulation frame-relay MFR1
no ip route-cache
service-module t1 timeslots 1-24
no arp frame-relay