Richard Burts Tue, 11/13/2007 - 07:30
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Dwight


You can certainly route between the FastEthernet ports of the 1841. Eash FastEthernet is an independent routed layer 3 interface. I have set this up a number of times and it works quite well. Just put an IP address and subnet mask on FastEthernet0/0 and another IP address and subnet mask on FastEthernet0/1. The 1841 automatically routes between these subnets. Of course you will need some source of routing information (static routes or dynamic routing protocol) for networks and subnets that are not locally connected.


HTH


Rick

Actions

This Discussion