AP1220 not broadcasting networks

rodonohu1 · ‎11-13-2007

Hi,

I have an AP1220 configured connected to trunk port on a 2980 switch. On the AP i have it setup like this on the Dot1Radio0 Interface:

interface Dot11Radio0

no ip address

no ip route-cache

!

ssid Internal

vlan 7

authentication open

guest-mode

!

But the SSID is not getting broadcasted out. I have the same setup on another AP in another office and its working fine. Any ideas why it is not broadcasting my network? could it be faulty?

Thanks,

rob.

gmarogi · ‎11-19-2007

go into the AP GUI and enable Broadcast SSID checkbox in the corresponding page and click Apply. Restart and see if the problem still persists.