11-13-2007 04:57 PM - edited 03-05-2019 07:24 PM
Is there a proper way to route VLAN 100 and 200 from switch1 across routers to switch2 in the scenerio below so that pc2 would acquire vlan100 and 200?
pc1 -> switch1 3560(vlan 100, vlan 200) -> 2811_router1 (eigrp) -> Point-2-Point -> 2811_router2 (eigrp) -> switch2 3650 -> pc2
thanks for your input.
hieu
11-13-2007 09:27 PM
HI, [Pls Rate if HELPS]
Considering your scenario:
Switch:
VLAN100 - 10.1.0.0
VLAN200 - 10.2.0.0
==> Disable STP feature
>> Create an Interconnection VLAN as VLAN300 (STP enabled) with Subnet 10.3.0.0 ( connecting Switch <---> Router interfaces)
>> Use TAGGING feature (with Up-link Port) to carry VLAN 100, 200 further to other end.
>> Repeat this Scenario at the other side also.
Router:
Go to EIGRP Configuration Mode
>>Advertise as "network 10.0.0.0"
Do Rate if HELPS
Best Regards,
Guru Prasad R
11-14-2007 09:24 AM
Thanks Guru for your response. I'll try it out when I've a chance.
hieu
11-18-2007 03:32 PM
Guru,
Can you please provide a sample configuration of this?
TIA.
PF
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: