cisco 2811 + HWIC-4ESW 4 routable networks

Unanswered Question
Nov 14th, 2007

i have cisco 2811 and HWIC-4ESW is there a way to create config to have 4 routable networks, two networks on integrated interfaces and 2 networks on one of 4 interfaces of HWIC-4ESW card. and all networks should be route traffic when i configure 4 gateways on interfaces. so i need 4 routed networks 2 connected on integrated int. and 2 on HWIC-4ESW card. does networks from integrated interfaces can route traffic to routable two interface on HWIC-4ESW.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Edison Ortiz Wed, 11/14/2007 - 06:31

On HWIC-4ESW interfaces, you need to assign port membership and a SVI.

interface f1/0

switchport mode acess

switchport access vlan 10

interface f1/1

switchport mode access

switchport access vlan 20

interface vlan 10

ip address A.A.A.x x.x.x.x

interface vlan 20

ip address B.B.B.x x.x.x.x

and the regular interfaces, just directly enter the IP address there.

Routing is enabled by default and the interfaces above will be listed in the routing table as 'connected'.

End devices should point to this router as the default gateway on their respective subnets.



This Discussion