Richard Burts Wed, 11/14/2007 - 05:54
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Gerhard


Try configuring a trunk on the switch that includes that VLAN.


HTH


Ric

rsohi Wed, 11/14/2007 - 08:11
User Badges:

Hi Gerhard, try the following commands:


int vlanXXX

vlan XXX


I have used this in the past and it tends to bring the vlan ints up.


regards,

Raj

config terminal

!

interface Vlan1

ip address 192.168.0.1 255.255.255.0

no autostate

no shutdown

!

interface Vlan2

ip address 192.168.1.1 255.255.255.0

no autostate

no shutdown

!

interface Vlan3

ip address 192.168.2.1 255.255.255.0

no autostate

no shutdown

!

int range FastEthernet0/1 - 8

switch access vlan 1

switch mode access

!

int range FastEthernet0/9 - 16

switch access vlan 2

switch mode access

!

int range FastEthernet0/17 - 24

switch access vlan 3

switch mode access

!

end


produces the following results with all ports unplugged.

jedavis Wed, 02/06/2013 - 07:38
User Badges:

What IOS version supports the autostate command?  I just loaded 15.0(2)SE IP base on a 3560v2 and this interface command is not available.


-Jeff

mahmoodmkl Wed, 02/06/2013 - 19:46
User Badges:
  • Gold, 750 points or more

Hi
i think u have ti type it

Sent from Cisco Technical Support iPhone App

Actions

This Discussion