RME 4.0.5 - FWSM with multiple context - config archive

Andri_Try · ‎11-14-2007

Hi all

Is it possible to make config archive from multiple context FWSM with RME in CiscoWorks?

RME reports config archive successful and Debug has no errors. RME is successfully making config archive from one context and the system context. It seems not to notice the other contexts.

The Device in question:

Cisco Catalyst 6000 FWSM (Multiple Security Contexts)

Current setup:

LMS 2.6

RME 4.0.5 + Catalyst 6000 IOS Switch Series Package.

Any suggestions or ideas?

Regards

Andri

yjdabear · ‎11-14-2007

There's a footnote on that:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.0.3/device_support/table/RME403SI.htm

"5. After adding the device into the DCR, and whenever the device is switched between the Single and Multi Security Context Modes, the device should be deleted and added again into the DCR. This is due to change in the sysobjid and also because the number of configurations for the device varies when there is switching between the modes."