Restore CM 4.1(2) to 4.1(3)

Answered Question
Nov 14th, 2007

Hi

I need to rebuild and then restore a backup of CM 4.1.2 but I cannot find the disks. Is there any way I can use 4.1(3) disks and restore into that.

Thanks

I have this problem too.
0 votes
Correct Answer by rob.huffman about 9 years 2 months ago

Hi Michael,

Sorry to say, this is not a supported method :( Here is a clip from the CCM 4.1(2) Backup and Restore documentation;

Do a system restore on the same Cisco CallManager version. Changes from release to release cause problems if you try to restore from a different version.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_troubleshooting_guide_chapter09186a00802e0e9d.html

Hope this helps!

Rob

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
rob.huffman Wed, 11/14/2007 - 07:43

Hi Michael,

Sorry to say, this is not a supported method :( Here is a clip from the CCM 4.1(2) Backup and Restore documentation;

Do a system restore on the same Cisco CallManager version. Changes from release to release cause problems if you try to restore from a different version.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_troubleshooting_guide_chapter09186a00802e0e9d.html

Hope this helps!

Rob

Actions

This Discussion