1240 AP debug commands

Unanswered Question
Nov 14th, 2007
User Badges:

Does anybody know if there is a Debug command on the wireless 1240 IOS AP that will basically show what you get with the "show dot11 associations-all"? I'm looking mostly at the client MAC and the Signal strength/SNR values. Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
gmarogi Tue, 11/20/2007 - 12:55
User Badges:
  • Bronze, 100 points or more

Yes, There is a show command in these APs to show the client. The command reference document in cisco.com will help you to do that


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode