How to see gigabyte port information

Unanswered Question
Nov 15th, 2007

I need to now how long gigabyte port has been up (connected) in a Cisco 3750 switch.

What command permits me to know this?.

Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1.7 (3 ratings)
Loading.
umedryk Wed, 11/21/2007 - 11:53

Issue the command show ip interface brief to view whether the switch has Gigabit port and then Issue the command show interface gigabit ethernet < port number>.

This command gives all information like MTU, MAC address and speed.

mirtenmous Thu, 11/22/2007 - 02:34

You are not answering me.

These commands don't permit me how long gigabyte port has been up.

ilnaiduccna Thu, 11/22/2007 - 02:40

Hi,

Issued the command like #sh int g/2/35 instead of 2/35 you enter which port you want see.

Regards,

Naidu.

Kevin Dorrell Thu, 11/22/2007 - 05:35

I'm afraid the only way I know to do it is to have it syslog link-event traps. At least that way you get a written record as well.

Kevin Dorrell

Luxembourg

mirtenmous Thu, 11/22/2007 - 06:43

Yes but I haven't a syslog infraestructure.

Tha most seemed that I discovered that I will need is with sh log command that It shows that time when interface changed state to down and goes up again.

Actions

This Discussion