1242 AG Requiring Manual Boot

Unanswered Question
Nov 16th, 2007

Hi, I've got a 1242AG LAP that's registered to a 4400 Controller. Problem is, it won't boot properly. When I plug into the console port, I see the following:

The system is not configured to boot automatically. The

following command will finish loading the operating system

software:

boot

After issuing the boot command, the LAP runs just fine. I saw on another post a suggestion to ensure conf reg to 0xF, but nowhere either in the limited CLI on the LAP nor on the controller can I find where this is possible to set.

Any help would of course be most welcome.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode