cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
472
Views
0
Helpful
3
Replies

switch port on multiple vlans

jimb
Level 1
Level 1

On the old 3500xl we could use the multi-VLAN command to set up a port to allow more than one VLAN on a port that is not trunked. Can this be done on a 2960?

3 Replies 3

Kevin Dorrell
Level 10
Level 10

No, they abandoned that feature.

Kevin Dorrell

Luxembourg

Anybody got a work around or a trick to allow a port to be assgined to more than one VLAN for access mode?

I was able to do it, but with a data and a voice vlan (but I'm not sure if your IOS will support it. Here is my config on the port.

interface FastEthernet0/6

switchport trunk encapsulation dot1q

switchport trunk native vlan 7

switchport mode trunk

switchport voice vlan 100

switchport priority extend cos 3

spanning-tree portfast

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco