Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
224
Views
0
Helpful
1
Replies

can we configure Failover using out side interface in ASA5540

Jacob Samuel
Level 1
Level 1

‎11-16-2007 10:57 PM - edited ‎03-11-2019 04:32 AM

Hi Friends,

I need some information about Failover configuration with ASA.

I have an ASA5540 Box with failover unit, I want to configure statful fail over between this. plz find my queries

1) Do i require a dedicated intrerface for configuring stateful failover in ASA?

2) Can i configure Failover by using the Outside interface connecting to a L2 switch ?

3)Is thre any other option to configure the same with out using a dedicated interface, since i have short of ports for the failover?

I am sorry if i am wrong in the concept. I dont have any exp. in firewalling technology.

Thanks in advance

regards

Jacob

Labels:
0 Helpful
1 Reply 1

srue
Level 7
Level 7

‎11-17-2007 02:05 AM

you can use your failover lan interface as your stateful failover interface.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card