question from yesterday with more details

Unanswered Question
Nov 17th, 2007
User Badges:

Hi,


yesterday I posted a question:

hello,

I have a question on how to configure that the same call goes and gets back over the same B (bearer) chanell in dial-peer pots configuration and what the configuration steps to achieve this would be?

you replied that it isn't possible and asked me to tell you what do I need it for.

Well I've been asked too and today got an explanation what was the intention. So here it is:


customer should do bit error rate test with local telecom. Local telecom is looking for the following:


1. telecom calling some number


2. customer Cisco AS5350 should send back that call via same channel, not via new channel



this is from Telecom tests table:



BER test (preferable 1 hour) according to G.821 parameters (loop back on BRA).


Thank you very much and sorry for bothering

Have a nice day

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Sat, 11/17/2007 - 08:44
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi,


unfortunately I think this is not possible. Have you contacted your cisco office ? Perhaps they can check with engineering if there is a way they can provide a command to enable B-channel loopback in order to pass B-channel loopback test.


However, the whole controller can be put in loopback and this is enough for an accurate BER test.


Actions

This Discussion