Can't access remote resource in ASA VPN

Unanswered Question
Nov 18th, 2007

I created a VPN on ASA5510. I can establish the VPN, but can't access any resources. Also I can't access the Internet after establish the VPN. Any suggestions?

The configuration can be found this link:

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ajagadee Sun, 11/18/2007 - 09:52

If you are able to connect and not able to access-resources, check for

NAT 0 - configured to bypass NAT for VPN Clients

Access-lists - Applied on the inside or DMZ

Routing - Make sure that the LAN inside the ASA knows where to route the traffic for the pool of IP Addresses assigned to the clients.

For Internet connectivity after VPNed into the ASA, You have two options

Split Tunneling or Permit Same-interface



** Please rate helpful posts **


This Discussion