Failed to access ACS SE console after bootup

Unanswered Question
Nov 18th, 2007
User Badges:

Hi,


I set the baud rate to 115200, when ACS SE bootup it display the bootup message, I failed to console in using the same baud rate after ACS SE fully bootup.


I had try all the baud rate setting but failed to access through console.


What could be the problem, console port failure or the setting on ACS SE?


regards,


Sam


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jagdeep Gambhir Mon, 11/19/2007 - 13:56
User Badges:
  • Red, 2250 points or more

Is it a new appliance ? What is the message you get on console during boot up ? Ia it happening after configuring initial setup and reload ?


Regards,

~JG

ccsam Wed, 11/21/2007 - 19:31
User Badges:

Hi JG,


It's production unit where I can access using GUI.


When I reboot the ACS SE, I can see the bootup message from the console using 115200.


After fully boot up, the console port cannot be access even though I can the baud rate to all other setting.

Actions

This Discussion