11-18-2007 05:37 PM - edited 02-21-2020 10:19 AM
Hi,
I set the baud rate to 115200, when ACS SE bootup it display the bootup message, I failed to console in using the same baud rate after ACS SE fully bootup.
I had try all the baud rate setting but failed to access through console.
What could be the problem, console port failure or the setting on ACS SE?
regards,
Sam
11-19-2007 01:56 PM
Is it a new appliance ? What is the message you get on console during boot up ? Ia it happening after configuring initial setup and reload ?
Regards,
~JG
11-21-2007 07:31 PM
Hi JG,
It's production unit where I can access using GUI.
When I reboot the ACS SE, I can see the bootup message from the console using 115200.
After fully boot up, the console port cannot be access even though I can the baud rate to all other setting.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: