Wireless Mesh Config

conkinkinconkinkin · ‎11-19-2007

Hi all,

I need to config wireless mesh system.

I have Wireless Control System, Wireless Lan Controller 2100, and access point 1310

Any one can tell me step to config this sys tem.

Thanks all, vote 5* for your help.

bbxie · ‎11-19-2007

1310 not support mesh, you should use 1510/1520. for configuration example, you can refer to: http://www.cisco.com/en/US/products/ps6548/prod_configuration_examples_list.html

conkinkinconkinkin · ‎11-20-2007

Hi all,

Thanks bbxie, I voted 5* for your help

I have AIR-BR1310G-A-K9, are you sure this product is not support mesh? Can you show me document to ensure that?

If it not support mesh, can i build wireless network with this access point and wireless lan controller:

- All ap use the same ssid, same security policy

- Roaming between wireless area

Can you tell me step to deploy that?

conkinkinconkinkin · ‎11-20-2007

Any one can tell me step to config wireless network using accesspoint AIR-BR1310G-A-K9 and Wireless Controller 2100:

- All ap use the same ssid, same security policy

- Roaming between wireless area

?

n.manlangit · ‎11-25-2007

1310 is not a lightweight AP,, therefore it will not communicate with the lightweight controller 2100.....

conkinkinconkinkin · ‎11-26-2007

I configed 1310 in lightweight AP mode, it joined Controller 2100.

Any one know how to config roaming in my case or it is default?

Thanks

Richard Atkin · ‎11-26-2007

Roaming between APs on your WLC is enabled by default.

conkinkinconkinkin · ‎12-14-2007

Hi all,

I configed wireless system with controller 2100 and AP 1310

Almost the time system run normally, but sometime one of AP 1310 reboot, but other still run normally.

I don't know why, do you have any suggest about this problem?

How to view log all event on this system?

Thanks all for help