waiting for interdigit timeout on directory transfer?

Unanswered Question
Nov 20th, 2007
User Badges:

Hi all.

Im running a UC520, CCME/CUE. When I transfer a call to an external mobile, or a number in out directory / speed dial list, theres a pause of around 5-10 seconds before the transferred number is dialled. Im assuming this is an interdigit timeout issue?

Below is my transfer pattern setup, could somebody suggest how to speed things up a little?


transfer-system full-consult dss

transfer-pattern 9.T

transfer-pattern .T

secondary-dialtone 9

(PS im in the UK. So I need to transfer to 11 digit mobiles and landlines. Our internal extension range is 3 digits, but they appear to work fine when you just type in the 3 digit number to transfer the call to so thats OK)

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
vmoopeung Mon, 11/26/2007 - 09:38
User Badges:
  • Bronze, 100 points or more

you need to wait until the T302 timer expires before the Cisco CallManager accepts the CFA extension. By default, this timer is ten seconds. If this delay is too long, change the T302 service parameter to a shorter length of time, for example, five seconds

Paolo Bevilacqua Mon, 11/26/2007 - 10:25
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, you have two remedies, not mutually exclusive:

1. configure transfer-pattern to external number according the UK dialplan, put as many digits and dots as necessary, do not use T. You many need multiple transfer-pattern depending on leght and pattern of numbers.

2. under telephony-service, configure timeouts interdigit to 3 or 4.

hope this helps, please rate post if it does!


This Discussion