Rob Huffman Tue, 11/20/2007 - 09:03
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Greg,


Each controller is configured with a list of the other members of the mobility group. Whenever a new client joins a controller, the controller sends out a unicast message to all of the controllers in the mobility group. The controller to which the client was previously connected passes on the status of the client. All mobility exchange traffic between controllers is carried over an LWAPP tunnel.


From these excellent docs;


http://www.cisco.com/en/US/docs/wireless/wcs/4.1/configuration/guide/wcsmobil.html#wp1090318


http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/c40mobil.html


Hope this helps!

Rob

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode