cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
250
Views
0
Helpful
2
Replies

MLA CUCM 4.1(3) query

UCBNOCWAN
Level 1
Level 1

We are running CUCM 4.1(3). MLA is not enabled & value is set to " False". Is it possible to enable MLA & then disable it again, if it's required?

1 Accepted Solution

Accepted Solutions

Hi,

Yes, We can enable and disable the MLA options.

After enabling the MLA, if you disable it,the CCMAdministrator Account will not be used and all the restrictions will given to the users and user groups will be removed .i.e, basically all the MLA Configuration will not be in place. The windows Administrator Account will used for CCMAdmin Page Authentication.

And refer the below link for more detailed info:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803eda81.html

Thanks,

Kumar.V

View solution in original post

2 Replies 2

Hi,

Yes, We can enable and disable the MLA options.

After enabling the MLA, if you disable it,the CCMAdministrator Account will not be used and all the restrictions will given to the users and user groups will be removed .i.e, basically all the MLA Configuration will not be in place. The windows Administrator Account will used for CCMAdmin Page Authentication.

And refer the below link for more detailed info:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803eda81.html

Thanks,

Kumar.V

Kumar,

Thanks a lot. Actually I was doing a bit of research myself & found that it's possible from the back-end also. In SQL Enterprise Manager, we have to go to "MLAParameter" table in CCM 003XX database & change F to T & then restart IIS Admin service.

Regards,

Abhijit. ( Bangalore)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: