Edison Ortiz Wed, 11/21/2007 - 07:54
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Yes, you can configure IP SLA to ping a host and associate this SLA to a track.


On the HSRP configuration, you can use the track option instead of the interface.


Please read this chapter and at the bottom of the chapter, a HSRP example is illustrated.


http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hiap_c/haipbtrk.htm


HTH,



Nagendra Kumar ... Wed, 11/21/2007 - 09:04
User Badges:
  • Cisco Employee,

Hi,


Yes you can configure "track ip route" command to achieve the same.


Regards,

Nagendra

cisconoobie Wed, 11/21/2007 - 09:12
User Badges:

track ip route is not an option


Core(config-if)#standby track ?

<1-500> Tracked object number

Async Async interface

BVI Bridge-Group Virtual Interface

CTunnel CTunnel interface

Dialer Dialer interface

Filter Filter interface

Filtergroup Filter Group interface

GigabitEthernet GigabitEthernet IEEE 802.3z

Lex Lex interface

Loopback Loopback interface

Port-channel Ethernet Channel of interfaces

Portgroup Portgroup interface

Pos-channel POS Channel of interfaces

Tunnel Tunnel interface

Vif PGM Multicast Host interface

Virtual-TokenRing Virtual TokenRing

Vlan Catalyst Vlans

fcpa Fiber Channel


Nagendra Kumar ... Wed, 11/21/2007 - 09:24
User Badges:
  • Cisco Employee,

Hi,


This command is a config mode command. Configure this command as below,


"track 1 ip route < ip addr/n> reachability"


and apply the same under interface using


int g0/0

standby 1 track 1


This will track the ip route and if the ip addr is not in routing table, the object will be down.


Hope this helps.


Nagendra

Actions

This Discussion