FWSM failover & bandwidth

Unanswered Question
Nov 21st, 2007

Hi,

I have 2 6500 with 2 FWSM cards configured as Actif/passif with a 1 giga of bandwidth between them.

The link is configured as 802.1q.

My question is how can I calculate the bandwidth use of failover and session traffics (except data traffic).

Regards

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sbaddipudi Wed, 11/21/2007 - 10:22

I don't have the exact answer, but remember that that your failover traffic is in a different vlan from your data traffic. Of course they are going over the same .1q trunk. show failover or the vlan stats may give you some idea but not the exact info you are looking for.

Satya

Actions

This Discussion