Creating new Enhanved IOS Conference Bridge in CM 4.2(3)

Unanswered Question
Nov 21st, 2007

I have a 3825 fully loaded with PVDM2. I have created a DSP farm and a profile for transcoders and a profile for conferencing. In CM, Im trying to create a new hardware conference bridge. What MAC address do I use? I have used CFB<MAC> where <MAC> is the MAC of the Gig interface on the 3825. After resetting the new CFB in CM, I still dont see an IP address in the CM window and sh sccp on the router indicates that both my transcoders and conference bridge are not registered


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Brandon Buffin Wed, 11/21/2007 - 11:20


The MAC address used to register with CCM will be that of the interface specified with the "sccp local" command on the 3825.

Hope this helps. If so, please rate the post.


jeffrey.girard Wed, 11/21/2007 - 11:23

Brandon -

I appreciate your response, but unfortunately, that is not it. Gig 0/0 IS the interface that I have specified in the sccp local command. I will try to post the config later


This Discussion