help configure VLAN with Cisco 2950

Unanswered Question
Nov 21st, 2007

I have Cisco Catalyst 4510R with two VLAN. Vlan1 and VLan2. I have a remote site that have a cisco 2950 switch. The remote site is connected to us directly. I want to be able to configure three ports on the remote site switch to be on and communicate with Vlan2 on the cisco 4510R.

Thank you

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
cisconoobie Wed, 11/21/2007 - 14:20

The 2950 is a layer 2 switch I believe so you need to make sure you have a trunk to that switch from the 4510.

Then on the 2950 configure the port like this:

int "port"

switchport mode access

switchport access vlan 2

johnisccp Wed, 11/21/2007 - 15:51

I am new to this so is there a way for me to find if there is a trunk to switch 4510R. The remote site is connect through a T1 internet line and traffice goes through Pix 515e.

Thanks

Actions

This Discussion