11-21-2007 12:30 PM - edited 03-05-2019 07:33 PM
I have Cisco Catalyst 4510R with two VLAN. Vlan1 and VLan2. I have a remote site that have a cisco 2950 switch. The remote site is connected to us directly. I want to be able to configure three ports on the remote site switch to be on and communicate with Vlan2 on the cisco 4510R.
Thank you
11-21-2007 02:20 PM
The 2950 is a layer 2 switch I believe so you need to make sure you have a trunk to that switch from the 4510.
Then on the 2950 configure the port like this:
int "port"
switchport mode access
switchport access vlan 2
11-21-2007 03:51 PM
I am new to this so is there a way for me to find if there is a trunk to switch 4510R. The remote site is connect through a T1 internet line and traffice goes through Pix 515e.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: