This is likely a very basic question....
I've got a new Cisco ASA5505 and I'm trying to see some logs at console level. Currently when I do a sh logging I simply get the below. I was expecting or I have seen on other PIX/ASA's system messages.
Any ideas on what command I need to run in order to enable these messages?
mipsasa01# sh logging
Syslog logging: enabled
Timestamp logging: disabled
Standby logging: disabled
Deny Conn when Queue Full: disabled
Console logging: disabled
Monitor logging: disabled
Buffer logging: disabled
Trap logging: disabled
History logging: disabled
Device ID: disabled
Mail logging: disabled
ASDM logging: level informational, 7108 messages logged
The "show log" displays what is known as the buffer log. Your buffer logging is disabled. Use the config cmd "logging buffered " to enable it. You can adjust the size of the buffer with "logging buffer-size ". I think the buffer space is allocated in memory so don't go overboard.