4402 with 1510 AP Configuration Questions

Unanswered Question
Nov 22nd, 2007
User Badges:

I'm currently setting up a wirless lan with a Cisco 4402 Wireless Lan Controller and 3 cisco 1510 Access points. Everything works fine the access points discover each other and I can get from one end to the other. It's very basic no DHCP servers static IP's layer2 mode. A couple of thing are bugging about it. 1. Inside the Access Points configuration information in the web GUI it tells me the AP IP Address is disabled which is not possible because if I enter the Command Line Interface it tells me what the IP address is. It also reports it can't use the static IP address and fails back to DHCP. Everything works so I don't get what's happening here. Question 2 the service port on the fron of the 4402 is setup and telnet and SSH session are enabled on it but I can't access the interface from it. The seesion sends but doesn't receive. I could really use some specific answers to these questions. Thanks for the help.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Atkin Fri, 11/23/2007 - 09:54
User Badges:
  • Silver, 250 points or more

Sounds buggy - are you using the latest version of code?


If you're only using MESH APs on the WLC, I'd suggest that you really should be using 4.1.190.5, which is specifically designed for MESH.

eraser134 Fri, 11/23/2007 - 13:11
User Badges:

I have one root and the other 2 are mesh. Can't find the download link for that verison of the could could post the link. Thanks

Richard Atkin Fri, 11/23/2007 - 23:51
User Badges:
  • Silver, 250 points or more

From www.cisco.com


1. Click "Support" (top of screen)

2. Click "Download Software"

3. In the 'Software Search' box, type 4.1.190.5

4. Download software appropriate to your WLC


Done.



Richard Atkin Sun, 11/25/2007 - 14:47
User Badges:
  • Silver, 250 points or more

If you're not willing to change code, the only other option is that you're config is wrong, so you could factory default it and start from scratch.


Console on to the WLC

Reboot the WLC

login using the username Recover-Config (case sensitive)


That will completely reset the WLC to factory default.

eraser134 Sun, 11/25/2007 - 15:05
User Badges:

What would the possible cause of these particular issues?

Actions

This Discussion