WLC 4404 and AP 1242 Lwapp mode (not work)

Unanswered Question
Nov 23rd, 2007
User Badges:

I'm connecting the AP model 1242 with a WLC4404.

i'm using a layer3 cisco for DHCP for to pass the option 43.

I use the WLC in the LWAPP L3 mode.

I doesn't work. I've connected my pc with the AP and attach the file txt with a log.


log of the AP 1242


......

i think that the problem is


%LWAPP-5-CHANGED: LWAPP changed state to CFG

%LWAPP-3-CLIENTERRORLOG: Config Request Timer: did not recieve config response (controller - WLC-1)

%SYS-5-RELOAD: Reload requested by LWAPP CLIENT. Reload Reason: DID NOT GET CONFIG RESPONSE.

%LWAPP-5-CHANGED: LWAPP changed state to DOWNXmodem file system is available.

flashfs[0]: 8 files, 3 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 15998976

flashfs[0]: Bytes used: 5404160

flashfs[0]: Bytes available: 10594816

flashfs[0]: flashfs fsck took 26 seconds.

Base ethernet MAC Address: 00:1d:a1:ce:39:dc

Initializing ethernet port 0...

Reset ethernet port 0...

Reset done!

ethernet link up, 100 mbps, full-duplex

Ethernet port 0 initialized: link is up

Loading "flash:/c1240-k9w8-mx.124-10b.JA/c1240-k9w8-mx.124-10b.JA"...################################################################################################################################################################################################################################################################################################################################


File "flash:/c1240-k9w8-mx.124-10b.JA/c1240-k9w8-mx.124-10b.JA" uncompressed and installed, entry point: 0x3000

executing...


--------------------------------------

and the AP go in loop.

I can try to connect a DNS server , but there aren't any change.


What can i go ?


thanks for your help


FC



Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Atkin Fri, 11/23/2007 - 10:04
User Badges:
  • Silver, 250 points or more

That certainly is in interesting one!


Few things though...


1 - What version of code are you using on the WLC?


2 - Is it possible to get a copy of the corresponding logs from the WLC?


3 - Are there any firewalls / ACLs between the AP & WLC?


My initial thoughts are;


A - Buggy code. Lots of people like to stick with old code and I really don't know why, so try upgrading this.


B - Comms error. The AP is certainly contacting the Management Interface, but I'm not sure about the AP-Manager interface. Double-check the config of both interfaces.


C - Comms restriction. Is there anything that would stop the AP using UDP 12,222 - 12,224 between its self, and the WLC Management & AP-Manager interfaces?




Take a look and get back to us.


Regards,

Richard

Actions

This Discussion