wan interface card configuration problem

Unanswered Question
Nov 23rd, 2007
User Badges:


we are using 2821 router with 1 NM-2CE1T1-PRI in slot 1 and 1 VWIC-2MFT-E1 card in HWIC 0 slot.the problem is that router is not taking the card type e1 0/card type e1 2 command.i have to configure 1 2MB link with unframed command on VWIC-2MFT-E1 card.router is taking card type e1 1 command on NM-2CE1T1-PRI(slot 0).pls suggest us what to do.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
jarredtaylor Sat, 11/24/2007 - 06:36
User Badges:


I believe on the VWIC cards you do not have to specify card type. Instead you configure the 'controllers' first. Afterwards the physical interfaces will show up in the config:

controller e1 0/0


interface s0/0:x



paolo bevilacqua Sat, 11/24/2007 - 12:48
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member


VWIC-2MFT-E1 does no support unframed operation.

For that, you will need VWIC-xMFT-G703 or VWIC2-xMFT-G703.

Hope this helps, please rate post if it does!


This Discussion