11-23-2007 09:17 PM - edited 03-03-2019 07:40 PM
hi,
we are using 2821 router with 1 NM-2CE1T1-PRI in slot 1 and 1 VWIC-2MFT-E1 card in HWIC 0 slot.the problem is that router is not taking the card type e1 0/card type e1 2 command.i have to configure 1 2MB link with unframed command on VWIC-2MFT-E1 card.router is taking card type e1 1 command on NM-2CE1T1-PRI(slot 0).pls suggest us what to do.
11-24-2007 06:36 AM
Parba,
I believe on the VWIC cards you do not have to specify card type. Instead you configure the 'controllers' first. Afterwards the physical interfaces will show up in the config:
controller e1 0/0
!
interface s0/0:x
HTH,
Jarred
11-26-2007 08:49 PM
thanks a lot, i will check this...
11-24-2007 12:48 PM
Hi,
VWIC-2MFT-E1 does no support unframed operation.
For that, you will need VWIC-xMFT-G703 or VWIC2-xMFT-G703.
Hope this helps, please rate post if it does!
11-26-2007 08:50 PM
thanks a lot...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: