11-24-2007 05:32 PM - edited 03-05-2019 07:36 PM
Anyone know if this is possible, and if so, have any sample configurations to do it? I've been digging around Google and not coming up with a whole lot, and considering the switch is on End-of-life status, Cisco isn't supporting it either.
Edit: We're looking to set it up on a per-port basis.
Thanks!
-Glen
11-24-2007 11:22 PM
Glen, this is discuntinue product, you will have to do a little better, most of newer catalyst switches can do per port rate limiting , Qos etc.. , go to product link bellow and pick product look in data sheets and software feature information , it will indicate its capability in this technology.
For example I see these support rate limiting Catalyst 2960 LAN-base, 3560, 3560-E, 3750 etc..
For details refer to data sheets and/or software features ( Granular rate limiting)
http://www.cisco.com/en/US/products/hw/switches/index.html
HTH
Jorge
11-26-2007 07:06 AM
Jorge,
Thank you for the response, but just so I am 100% clear and can report the correct information to my boss....are you saying the 5509 is not capable of rate limiting on a per port basis?
Thanks!
-Glen
11-26-2007 07:10 PM
Hi Glen, base on data sheets reports on bellow link , no it is not supported, doing a search on product rate limiting is not found in any of 5500 models.
ALL 5500 Series data sheets report
http://www.cisco.com/en/US/products/hw/switches/ps679/products_data_sheets_list.html
rate any helpfull post if it helps.
HTH
Jorge
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: