Trunking ASA 5505 and Cisco 1200 AP

Unanswered Question

Hi all,

I think I know the answer to my post but I would like a second opinion.

I am trying to trunk a Cisco 1200 AP to an ASA 5505. The AP must have a native VLAN on VLAN 1 according to this link:

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43vlan.html#wp1038979

The ASA 5505 supports trunking but no native VLAN support.

http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/int5505.html#wp1057200 (see bottom of step 2).

Then I assume that if I want to do this, I'll have to put a switch in the middle, right?

The other option is to use a WLAN controller and tunnel all VLAN within the LWAPP tunnel.

Any other suggestions?

Thanks

Martin

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gomeso Wed, 03/26/2008 - 12:01

Is there any possible way or suggestion other than putting a switch in the middle to accomplish this setup (AP trunk to ASA)? Please advise. Thank you.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode