transparent mode Firewall with 4 ports transparent mode Firewall with 4 por

Unanswered Question
Nov 26th, 2007

Dears,

i have Firewall with 4 ports FE is configured as transparent mode..... how many interfaces i can configure in this mode.

i heared just one output interface and one input interface i can configure in this mode...is that true?

or can i configure 2 FE as output and 2 FE as Input.

thx for any advice or help.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sachin.verma Mon, 11/26/2007 - 23:52

Hi,

Kindly provide the software and hardware details of your firewall.

regards

Sachin Verma

johann.giese Thu, 02/14/2008 - 19:45

Hi,

Dou you have info about this ?

Can you configure only 2 or 4 interfaces ?

Regards

mtloader Sun, 02/17/2008 - 11:25

Greetings,

Accoding to the ASA manual:

Note Transparent firewall mode allows only two interfaces to pass through traffic; however, on the The ASA 5510 and higher adaptive security appliance, you can use the Management 0/0 interface (either the physical interface or a subinterface) as a third interface for management traffic. The mode is not configurable in this case and must always be management-only.

Also if you desire yopu can configure your device in multiple context mode and use all 4 interfaces. 2 for each context.

Hope this helped.

Actions

This Discussion