11-26-2007 02:08 AM - edited 03-11-2019 04:35 AM
Dears,
i have Firewall with 4 ports FE is configured as transparent mode..... how many interfaces i can configure in this mode.
i heared just one output interface and one input interface i can configure in this mode...is that true?
or can i configure 2 FE as output and 2 FE as Input.
thx for any advice or help.
11-26-2007 11:52 PM
Hi,
Kindly provide the software and hardware details of your firewall.
regards
Sachin Verma
11-27-2007 07:20 AM
it is ASA5510 and software ASA Version 7.2(2) .
02-14-2008 07:45 PM
Hi,
Dou you have info about this ?
Can you configure only 2 or 4 interfaces ?
Regards
02-17-2008 11:25 AM
Greetings,
Accoding to the ASA manual:
Note Transparent firewall mode allows only two interfaces to pass through traffic; however, on the The ASA 5510 and higher adaptive security appliance, you can use the Management 0/0 interface (either the physical interface or a subinterface) as a third interface for management traffic. The mode is not configurable in this case and must always be management-only.
Also if you desire yopu can configure your device in multiple context mode and use all 4 interfaces. 2 for each context.
Hope this helped.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: