cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
241
Views
0
Helpful
1
Replies

BUG (?) in the ospf ABR LSA Type 3 filtering

simaskvilius
Level 1
Level 1

Hi,

I'm working with following topology: http://www.talpink.lt/images/v.php?id=29126p2.JPG

Device configurations can be found here:

http://pastebin.com/f4eee9384

The result of

area 0 filter-list prefix F1 in

command executed in R2 router was very strange, as supposed, this command filtered summary LSA of 10.0.0.0/24 prefix in Area 0 (prefix 10.0.0.0/24 disappears from R3's routing table and LSA database as supposed), however 10.0.0.0/24 is still injected into Area 2 as Type 3 LSA (and to any other areas which are directly connected to R2), this is definitely a bug (probably caused by LSA injection optimizations), type 3 LSA should never be injected from one non-backbone area to another.

1 Reply 1

mchin345
Level 6
Level 6

area area-id filter-list prefix {prefix-list-name in | out} specify the out parameter in your ABR (ie) Prefix list applied to prefixes advertised out of the specified area to other areas.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco