Problem of EIGRP

Unanswered Question
Nov 26th, 2007

Hi my seriors, I am new in networking field and preparing for lab is three router r1,r2,r3.



eigrp enabled,network=,

s0=dte,connected to r2 so,dce.


r2=s0=,,dec cable

s1= , dec cable att





r3=s1= dte attached to r2 on s1.


eigrp enable,network=,

My question. 1.Network lo0 on r3 not beign advterised in this configuration. but when i changed the network command on r3 form to ,other routers noted the network and added into their table. I could not understand. Thanks for reply.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Kevin Dorrell Mon, 11/26/2007 - 14:59

If you have configured network in EIGRP, then have a look at a show run to see how it has handled it.

In fact, the network command is expecting a wildcard mask (like an access-list does), and not a subnet mask. You need network instead.

But in any case, that network command would not cover your Lo0 on R3. You would need something like network

Kevin Dorrell



This Discussion