Please find the output of my router. I'd tried to implement some QOS to my router. But after implementing the same I found that the serial interface's available Bandwidth is showing 8 kilobits/sec only.
Also my target is to putting best value for ABC_ACL data. Next DEF_ACL data and then GHI_ACL data. Find the attachment for mote details.
Please suggest how can I put all this required traffic to a QOS.
Thanks & Rgds
Your QoS config looks fine.
A quick math check will show exactly how much bandwidth in kbps that you're allocating for each class as shown in ( ).
Your line speed is set at 64 kbps, and the total allocated bw is 57.6 kbps. The remaining 8 kbps that you see when you issue "show int" is for your class class-default.
bandwidth percent 70 (44.8 kbps)
bandwidth percent 10 (6.4 kbps)
bandwidth percent 10 (6.4 kpbs)