11-27-2007 03:44 AM
We have the following VoIP setup:
Site1_PBX---VoIPgw--**network**--VoIPgw--Site2_PBX
ISDN type: E1 PRI
Both gateways have 03 E1 PRI setup, so total, we have 90 B channels. It seems the router select the B channel randomly.
We need to have a logical sequence of B selection for each gateway:
First E1 will be selected and B channel will be selected from 1 to 30 sequencially
the second E1 will be selected once the first e1 is fully used (all 30 B channels are used) and B channel will be selected from 1 to 30 sequencially
the third E1 will be selected once the first and the second e1 is fully used (all 30 B channels are used) and B channel will be selected from 1 to 30 sequencially
Thanks for your quick feedback as this is urgent for users
Mohamed
11-27-2007 07:11 AM
Hi,
No the router does not select B-channel at random. It always uses ascending or descending order. To have an order whitin the different interfaces, configure them in a sequential trunk-group.
Hope this helps, please rate post if it does!
11-27-2007 07:23 AM
hello,
Thanks for your response.
Do you have any related documentation about trunk-group?
Which Cisco IOS command should i use?
Appreciate your help
11-27-2007 09:05 AM
Hi,
Under serial x/y interface, specify a trunk-group with a name of your liking, and a priority if necessary.
Under DP pots, specify the same trunkgroup instead of port.
Optionally, under "trunk group
That's it.
As a recognition to those providing answers, please rate useful posts using the scrollbox below!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: